QoS Parameters for a Single Port

QoS Parameters for a Single Port

Switch1 (enable) show port qos 10/3

Config:

Port  ACL name                         Type

----- -------------------------------- ----

10/3  list1                            IP

QoS access list can either be implemented for a specific port, port-based, or to the entire VLAN, vlan-based. Access list, list1, was created for port-based only, which means the access list will not affect other hosts on the same VLAN. By default, Cisco switches are configured for port-based. However, if needed, the set port qos command can be used to change the QoS access list configuration to vlan-based.

Switch1 (enable) set port qos 10/3 vlan-based