E&M Signaling

E&M Signaling

E&M signaling supports tie-line type facilities or signals between voice switches. Instead of superimposing both voice and signaling on the same wire, E&M uses separate paths, or leads, for each.

To call a remote office, your PBX must route a request for use of the trunk over its signal leads between the two sites. Your PBX makes the request by activating its M-lead. The other PBX detects the request when it detects current flowing on its E-lead. It then attaches a dial register to the trunk and your PBX, which sends the dialed digits. The remote PBX activates its M-lead to notify the local PBX that the call has been answered.

There are five types of E&M signaling: Type I, Type II, Type III, Type IV, and Type V. The E&M leads operate differently with each wiring scheme, as shown in Table 2-1 and Table 2-2. Keep in mind that any of the E&M supervisory signaling types (that is, wink-start, immediate-start, and delay-start) can operate over any of the following wiring schemes.