E&M Delay-Start Signaling
Delay-start signaling, as depicted in Figure 2-19, is the original start protocol for
E&M.
Delay-start is used when all of the
equipment is mechanical and requires time to process requests. The following
scenario summarizes delay-start signaling:
-
When you place a call, your calling switch goes off hook by
activating its M-lead.
-
The called switch acknowledges the request by activating its
M-lead, and then rotates armatures and gears to reset its dial register to
zero.
-
When the dial register at the called switch is in the ready
state, the called switch deactivates its M-lead.
-
The calling switch then sends dialed digits. DTMF tones are
forwarded across the E&M link in the audio path, not on the M-lead
-
When the called party answers, the called switch again
activates its M-lead.
Echo
Although a local loop consists of two wires, when it reaches
the switch, the connection changes to four wires with a two- to four-wire hybrid
converter. Trunks then transport the signal across the network, as shown in Figure 2-20.
Sections
Comments (0 posted)
Syndication
